Aairex Environmental
|
Aairex Environmental
|
|
|
Circular Ductwork Aairex Circular Ductwork is manufactured from prime quality cold reduced continuously hot dipped galvanised commercially flat sheet steel, complying with BS 2989 Group 2 – Class 2A. All Ductwork is lockformed construction and supplied in standard lengths. Ductwork sized from 100mm Æ to 500mm Æ inclusive, is supplied from our Aairex standard range and will be joined together using our RLPR clips. Bends and Fittings normally have a minimum throat radius equal to the diameter of the duct. Where short radii bends are used due to site limitations, they will be discussed and agreed with your Engineer. All Bends from 100mm to 400mm Æ inclusive, are pressed and Bends above 400mm Æ are segmented with paned joints. All Ductwork and Bends above 500mm Æ are supplied with flanges at each end for ease of Site assembly. Square/Rectangular Ductwork Aairex Square/Rectangular Ductwork is manufactured from prime quality cold reduced continuously hot dipped galvanised commercial coil, complying with BS 2989 Group 2 – Class 2A. All Ductwork is lockformed construction and supplied in standard lengths. Ductwork sized from 150mm sq to 1500mm sq inclusive, is supplied from our Aairex standard range and is flanged for site installation. Key Benefits
Selection of Pullrings & Flanges Duct Installation |
|
Send mail to aairx@iol.ie with questions or comments about
this web site.
|
