|
Please Read Guide Before Use
Create a
Mystique with a Mist Maker Fogger Unit
It utilizes electrical oscillation frequencies,
via ceramic disc's high frequencies resonance to
create natural white mist (fog) on the surface of
water with no chemicals, no dry ice needed what so
ever, simply place it into clean tap water and see
the cool-steam fog vapour ethereally rising out of
water immediately, the mist adds healthy moisture to
any dry environment and the beneficial negative ions
generated by the mist maker unit help to freshen
air, adding few drops of fragrant oil to the water
will produce an effect similar to an incense burner
and give you a clean dreaming space.
Mist Maker Safety
instructions, read before initial operation
1. Use only the transformer and accessories
supplied with the water fogger.
2. Do not touch the ceramic disc of water fogger
while in operation.
3. Do not touch response switch of mist maker while
remove misting unit from water in operation.
4. Always disconnect the power supply before moving
or maintenance.
5. Do not allow power supply to get wet or gather
moisture.
6. Do not allow the mist maker unit electrical plug
connector to get wet.
7. Do not place a container, cup, cover or any other
object over the mist maker unit that completely
covers the mist maker. Water must be allowed to
circulate around the unit for cooling.
Instructions for use
1. Place the mister unit into a water container
placidly. No matter the size of the container, there
should be approximately 1 1/2 inches of water above
the ceramic disc of mist unit. The deeper unit sits
in the water, the less the mist coming out..
2. Connect the power cable leading from the mist
unit to the power cable of the transformer unit.
3. Plug the transformer unit into the A/C power
socket. If installed properly, it will begin
producing the mist immediately.
General suggestions for
optimum use
1. Do not operate fogger more than 8 hours per
day. Connecting the transformer to a timer will
insure your mist unit operating only when needed.
2. The mist unit sends up small jets of water while
in operation. Your container should be large enough
to prevent water from splashing outside the
container. Otherwise you need a water splash guard.
Do not place the unit where water spillage or
condensation will cause damage to furniture,
electronic products or floors.
3. Use of clean water is recommended. When the water
is dirty, change it with clean water in time (dirty
water will affect normal misting production).
4. Do not use household abrasive cleaners on any
part of the mist unit. You may clean it with soft
cloth in clean water.
Mist Maker Maintenance &
Water Fogger Ceramic replacement Disc/Disk and key
After operation the mist unit for some time, you
may notice a decrease in the amount of mist produced
or it may stop working altogether. At that time, you
should either clean or replace the ceramic disc.
There are two different size mist ceramic disks in
the market, big one size is 20mm (about 3/4 inch),
smaller one is 16mm (little less than 5/8 inch),
make sure you get the right one for your fogger.
Follow the instruction
below to change the disc/disk
1. Unplug the fogger power and remove fogger from
water container, dry it with soft cloth.
2. Using the replacement disc/key tool, insert the
key into the winding ring and turn counter
clockwise.
3. Remove the filler piece (washer) and ceramic
disc. IMPORTANT, note that there is a front and back
of the ceramic. Be sure to reinstall with the
correct side (No black colour ring side) facing up.
4. Clean mineral deposits on the ceramic with a soft
cloth and reinstall it or proceed to install a new
ceramic disk in the reverse order of the above.
5. The inside area of the fogger cavity must be
completely dry before the parts are installed.
|
